Sheet Pile Sales Division
Sheet Piling (UK) Ltd are UK stockists and suppliers of Japanese hot rolled sheet piles and light gauge steel sheet pile sections. We offer an extensive range of 400, 500 & 600mm wide sheet pile sections.
Sheet Piling (UK) Ltd offer a comprehensive range of new Japanese Steel 500 & 600 wide sections in high grade copper enriched steel, as well as large stocks (generally over 2500 tonnes) of good quality used European and Japanese sections.
The sheet piles are available in a range of sections, with section modulus values as follows: 1000cm3/m, 1800cm3/m, 2700cm3/m, 3150cm3/m & 3800cm3/m. This combined with the high yield steel quality combine to offer Consulting Engineers, Designers, Specifiers and Contractors a wider range of choice than previously available.
Additionally we have been appointmented as sole UK & Ireland suppliers of "hot rolled" interlocking corner and junction pile sections manufactured by 'Mannstaedt' Germanys leading specialist steel manufacturer.
LATEST - Sheet Piling UK now supply and install Vinyl and Composite sheet piles. Under agreement with CMI (CMI Waterfront Solutions), the USA's leading manufacturer of Vinyl and Composite sheet piles we can now offer a complete service for all your Vinyl or Composite pile requirements.
Services Offered
- NEW Vinyl & Composite Sheet Piles.
- Pile Sales directly from stock.
- Hires or Sale & Buy Back.
- Fabrication of Special Piles.
- Hire of Telescopic Leader Rigs.
- Hire of Silent Vibration Free Pile Press Equipment.
For further details and current stock lists please contact:
Emrys Goodfellow on 01772 794141 ext. 22
LATEST VINYL PILE PROJECT
Vinyl Piles Take Flight
In May 2007 Sheet Piling (UK) Limited were approached by Tier Consult to review a scheme for a ground attenuation pond for the A350 expansion programme at Airbus Broughton.
Sheet Piling (UK) Limited offered a solution using vinyl piles produced by Crane Materials International in Georgia USA. The piles required to be 6m long but had 2m projecting above ground level. The soil profile was generally silt & clay overlaying medium dense alluvial sand.
In October 2007 Sheet Piling (UK) Limited were awarded the Contract to provide vinyl sheet piling to the attenuation pond complete with a preformed capping beam. The section used is a CMI CL9900.
Installation work commenced in December 2007 using conventional piling methods of trestles and beams. The beams were lined with timber to prevent damage to the piles during installation.
The piles were installed using a 35 tonne crawler crane and 7RF vibratory hammer.
The interlocks to the piles were filled with Fusroc SWX swellable waterbar prior to installation.
Piles were driven to level or refusal with the 7RF vibratory hammer and then backdriven to final refusal using an impacting plate on the head of the pile to convert the energy in the vibratory hammer to an impacting action.
After completion of the installation of the piles a preformed capping section was fixed to the top of the piles.
Downloads
 - Sheet Pile Sales Division - Technical Information.
- Nippon Steel Sheet Piles - Technical Information.
|
